top of page

The following steps will hope to serve as a guide to helping you change out your ear lobe jewelry:

 

1. Wash your hands. Always wash your hands before touching your piercing.

2. Remove the old piece of jewelry by firmly grasping the front and the back in between two fingers (one hand on the front and another on the back) and then pull the two pieces apart from each other. 

3. You should have received a transfer tool that has a loop on one side and a small pin on the other side. Put the small pin side through the piercing hole from front to back.

 

00000IMG_00000_BURST20200410165536179_CO
00100lrPORTRAIT_00100_BURST2020041017160
00100lrPORTRAIT_00100_BURST2020041017162

4.Place the hollow part of the flatback post onto the pin on the back of the ear and push the transfer tool out the front of the ear with the piece of jewelry. (push don’t pull).

00100lrPORTRAIT_00100_BURST2020041017164
00000IMG_00000_BURST20200410171723388_CO

5.Slide the slightly bent pin of the end into the hollow post. Don’t forget to hold the back so it doesn't fall out. And make sure the end is completely pressed together to the post with none of the pin showing. If it’s hard to push together you can straighten the pin slightly or use gauze to wrap and cover the jewelry and get a better grasp.

00100lrPORTRAIT_00100_BURST2020041017190
00100lrPORTRAIT_00100_BURST2020041017192

6. You can store the transfer tool for future use.

Congrats you just changed your jewelry! Thanks again for purchasing jewelry and please let us know if you need anything else piercing or jewelry related!

bottom of page